Basic GigaVUE HC Series Connections and Configuration

This chapter describes how to establish your first configuration session with the GigaVUE-HCT and set the basic initial configuration options necessary to get the node up and running.

Refer to the following sections for details:

■   Connecting Power to the GigaVUE-HCT
■   Connecting Serial Console and Mgmt Ports
■   Configuring Basic GigaVUE- H Series Settings
o   Access the Command-Line Interface over the Console Port
o   Run the Jump-Start Script
o   Configure Modules and Enable Ports
■   Command-Line Basics
o   Command-Line Modes
o   Entering Commands in the CLI
o   Command-Line Syntax – Entering Commands
■   The Basic Commands
■   Completing the Initial GigaVUE H Series Setup