GigaVUE‑HC1-Plus Modules
The GigaVUE‑HC1-Plus has two bays for replaceable modules. The following modules are available for the GigaVUE‑HC1-Plus:
|
Module |
Description |
Section |
|---|---|---|
|
BPS-HC1-D25A60 and BPS-HC1-D35C60 |
Bypass Modules, GigaVUE‑HC1-Plus, with six SX/SR (50/125μm multi-mode) and six LX/LR single-mode inline network port pairs |
|
|
SMT-HC1A-R |
The embedded GigaSMART engine with 2.0 GHz capability. |
|
|
PRT-HC1-Q04X08 Module |
The PRT-HC1-Q04X08 line card module increases the port density and allows GigaVUE‑HC1-Plus to connect with GigaVUE TA Series and GigaVUE HC Series nodes with higher-speed (25Gb/100Gb) links. |
|
|
Generation 3 GigaSMART Card (SMT-HC1-S) |
Generation 3 GigaSMART module, (SMT-HC1-S) gives 80Gb throughput. |
|
|
PRT-HC1-X12 |
PRT-HC1-X12 provides twelve 10Gb/1Gb SFP+/SFP network, tool, hybrid, inline network, and inline tool ports. Moreover, 10Gb ports can be used as stack-link ports. |
|
|
BPS-HC1-D25A24 |
Bypass Combo Module, GigaVUE‑HC1-Plus, with two SX/SR (50/125μm multi-mode) inline network port pairs and four SFP and SFP+ copper port cages |
|
|
TAP-HC1-G10040 |
Copper TAP with 8 x 1Gb 1000Mb ports for either four TAPs or bypass copper (BPC) port pairs |
Modules are hot-swappable and can be installed in any available front bays in a GigaVUE‑HC1-Plus node. However, refer to Module Removal and Replacement Procedure (Hot Removal) for instructions – you must follow a specific procedure when removing modules to preserve node stability.
Note: The protected link will remain down after performing a shutdown and no shutdown on the BPS-HC1-D25A24 module, as well as during module Online Insertion and Removal (OIR) on the GigaVUE‑HC1-Plus chassis. Reloading the chassis will help to restore the link.
