Access the Command-Line Interface over the Console Port
Use the console port on the left side of the base chassis to access the GigaVUE‑HC1 as follows:
| 2.
|
Start a terminal application on the PC. Common terminal applications include TeraTerm, PuTTY, and Hyperterminal. |
| 3.
|
Select the COM port connected to the console cable attached to the control module. For example, COM1. |
| 4.
|
Configure the port settings for the console connection as follows: |
| o
|
Bits per second – 115,200 |
1 Setting COM Port Properties for the Console Connection shows an example of how these settings are configured in Hyperterminal.
| 1
|
Setting COM Port Properties for the Console Connection |
| 5.
|
Start the terminal connection. You may need to press Enter a few times before you see the login: prompt. |
| 6.
|
Log in to the command-line interface with the following default user account and password: |
User:admin
Password:admin123A!
The configuration jump-start automatically starts and forces a password change.
The system administrator must change the password on the default admin account through the jump-start script. The default password (admin123A!) is no longer allowed. Refer to Run the Jump-Start Script for details.
A password must meet the following standards:
| ■
|
include 8-64 characters |
| ■
|
include at least one numeral |
| ■
|
include at least one upper case letter |
| ■
|
include at least one lower case letter |
| ■
|
include at least one special character (for example, !, @, #, $, %, ^, &, or * – ASCII 0x21, 0x2F, 0x3A, 0x40, 0x5B, 0x5F, 0x7B, 0x7E) |
| ■
|
Must not include the user name or parts of full-name. |
At the Admin password? prompt in the jump-start script, enter a new password that meets the standards, then confirm the password.
You will also configure some Admin and Monitor level users with the procedure described in Initial User Account Configuration.