SMT-HC1-S (Gen 3 GigaSMART Card)

GigaVUE-HC1 now supports an additional Node called the Generation 3 GigaSMART card (SMT-HC1-S), which gives 80Gb throughput and can be used to provide the ThreatINSIGHT solution for security detection. Integrate this node with Threat Detection and Response functionality on GigaVUE-HC1 using GigaVUE-FM to enable faster provisioning and easier maintenance. Modules are hot-swappable. Refer to Hot Swapping Modules for instructions.

Note: There are no front end ports on this module.

Ports and LEDs

Generation 3 GigaSMART Card (SMT-HC1-S)

Maximum Modules Per Chassis

The maximum SMT-HC1-S number of modules per chassis is two.

Power LED (PWR)

The LED indicates the operational status of the module as follows :

●

OFF means the node is not powered up.

●

GREEN means the node is powered on.

Ready LED (RDY)

The LED indicates the operational status of the module as follows :

●

OFF means the node is inserted but not yet configured.

●

RED means the node has failed.

●

GREEN means the node is ready.

H/S LED

The LED indicates the operational status of the module as follows :

●

OFF means the node is in normal operation.

●

BLUE means the node is ready to be removed when the card is shut-down or not configured. LED turns on at insertion of module.

Hot Swap Button

The hot-swap button is not supported, but the command "card slot <slot id> down" can be used to hot-swap the module from the chassis.

Upgrade Instructions

The SMT-HC1-S card was introduced with GigaVUE-OS 5.10.00 to be inserted into the GigaVUE-HC1 Chassis. The GigaVUE-OS software is embedded in the GigaVUE-HC1 Chassis.

The addition of Threat Detection and Sensor image to GigaVUE-HC1 in GigaVUE-OS 5.10.01 increased the size of the downloaded file, which can cause failures when extracting the expanded image on the target.

To install the new image. Follow the guidelines in this topic.

Recommended Version

The recommended version will depend upon your usage of the SMT-HC1-S module:

Apps on the SMT-HC1-S card	Recommended version
Basic GigaSMART Apps	GigaVUE-OS 5.13.00
Gen 3 ThreatINSIGHT Sensor	GigaVUE-FM and GigaVUE-OS v5.13.01 or the latest LTS version

Upgrade Requirements

Upgrading from an older software version to GigaVUE-OS v5.10.01 or above is not supported. To upgrade to the latest software version, you must upgrade to GigaVUE-OS v5.10.00, first, before you upgrade to v5.10.01 or above.

To avoid failures, use the supported upgrade paths:

Apps on the SMT-HC1-S card	Supported GigaVUE-OS upgrade paths
Basic GigaSMART Apps	older version > v5.10.00 > v5.12.xx > v5.13.00
Gen 3 ThreatINSIGHT Sensor	older version > v5.10.00 > v5.10.01 > v5.13.01 or the latest LTS version