proxy-server profile
Required Command-Line Mode = Admin
Use the proxy-server profile command to to set up a proxy server profile, which enables the routing of specific internet traffic through a proxy. This includes URL category downloads, lookups, CRL revocations, and OCSP requests/responses.
This command is supported in SMT-HC3-C08 module on GigaVUE-HC3,SMT-HC1-S module on GigaVUE-HC1 and GigaVUE‑HC1-Plus.
Note: Only IPv4 addresses are supported in 6.8.00 release.
Note: A maximum of ten proxy-server profiles can be configured.
Note: When setting up the proxy-server profile, make sure to use a unique profile alias for each unique proxy-server configuration (proxy address, port, etc.) across all devices managed by GigaVUE‑FM. If multiple devices require the same proxy-server profile settings, use the same profile alias for those devices. This is necessary for a smooth upgrade when GigaVUE‑FMintroduces proxy-server profile management in upcoming releases.
The proxy-server profile command has the following syntax:
proxy-server profile alias <profile1>
protocol http
proxy-address <ipv4-address | domain name>
port <l4-port>
auth-type [none | basic]
auth-username <user-name>
auth-password [<cr> | <clear-text password>] # when hit enter, the password will be obtained as masked.
periodic-ping [enable | disable ] #default: disable
periodic-ping type http-connect
periodic-ping interval <1 - 10; default 5> #duration in minutes periodic-ping failure-retry <1 - 3; default 3>
exit
The following table describes the arguments for the proxy-server profile command.
|
Argument |
Description |
||||||
|
proxy-server profile alias <profile1> |
Specifies the name of the proxy-server profile. |
||||||
|
protocol http |
Specifies the protocol http. The http protocol supported is only access type. |
||||||
|
proxy-address <ipv4-address | domain name> |
Specifies the proxy-address as follows:
|
||||||
|
port <port> |
Specifies the port. |
||||||
|
auth-type [none | basic] |
Specifies the authorization type. |
||||||
|
auth-username <user-name> |
Specifies the authorization profile name. |
||||||
|
auth-password [<cr> | <clear-text password>] |
Specifies the authorization profile password. |
||||||
|
periodic-ping [enable | disable] |
Specifies enabling the periodic ping. By default this will be disabled by default. |
||||||
|
periodic-ping type http-connect |
Specifies the Periodic ping type. |
||||||
|
periodic-ping interval <1 - 10; default 5> |
Specifies the time interval at which the periodic ping should be sent. The time interval is from one to ten minutes. By default, five minutes will be configure. |
||||||
|
periodic-ping failure-retry <1 - 3; default 3> |
Specifies the number of times the periodic ping will be re-attempted. The default is three. |
Related Commands
The following table summarizes other commands related to the proxy-server profile command:
|
Task |
Command |
|
Displays the proxy-server profiles. |
# show proxy-server profile [all | alias <alias-name>] |
|
Displays ARP information for the GigaSMART engine port. |
# show gigasmart engine 1/1/e1 arp |
