card (GigaVUE®TA Series)

Required Command-Line Mode = Configure
Required User Level = Admin

Use the card command to specify how the GigaVUE TA Series node uses its physical 40Gb ports. This command also applies to white box nodes with GigaVUE‑OS.

The card command has the following syntax for GigaVUE-TA1, GigaVUE-TA10, and white box:

card slot <slot ID> mode <48x | 56x | 64x>

GigaVUE TA Series nodes only have a single card, so the slot value is always set to 1.

The following table summarizes the available options:

Card Mode

GigaVUE‑OS on a white box

q1

q2

q3

q4

48x (default)

40Gb (q1)

40Gb (q2)

40Gb (q3)

40Gb (q4)

56x

10Gb (x49..x52 on breakout panel)

10Gb (x53..x56 on breakout panel)

40Gb (q3)

40Gb (q4)

64x

10Gb (x49..x52)(x49..x52 on breakout panel)

10Gb (x53..x56)(x53..x56 on breakout panel)

10Gb (x57..x60 on breakout panel)

10Gb (x61..x64 on breakout panel)

Use break-out cables or breakout panels (PNL-M341 or PNL-M343). For breakout panel information, refer to the GigaVUE TA Series Hardware Installation Guide.