Configure Egress Port VLAN Stripping

You can enable or disable outer VLAN stripping on specified egress ports. Use egress port VLAN stripping to strip an outer VLAN tag without using a GigaSMART stripping operation.

Use the egress-vlan strip command to enable egress port VLAN stripping. The port type must be tool or hybrid.

The following examples enable egress port VLAN stripping:

Table 1: Enabling Egress Port VLAN Stripping

Command

Description

(config) # port 1/1/c2 egress-vlan strip

Enables outer VLAN stripping on a specified egress port.

(config) # port 1/1/c3..c4 egress-vlan strip

Enables outer VLAN stripping on a range egress ports.

Once egress port VLAN stripping is enabled, it can be disabled with the no port <port ID> egress-vlan command.

If a port is configured for egress port VLAN stripping, the port type cannot be changed until it is disabled. To disable outer VLAN stripping on specified egress ports:

Table 2: Disabling Egress Port VLAN Stripping

Command

Description

(config) # no port 1/1/c2 egress-vlan strip

Disables outer VLAN stripping on a specified egress port.

You can view egress port VLAN stripping using the show port params port-list bid/sid/pid command or the show egress-vlantag command.

 

The following examples display egress port VLAN stripping configuration:

Table 3: Showing Egress Port VLAN Stripping

Command

Description

(config) # show port params port-list 1/1/c2

Shows outer VLAN stripping on a specified egress port.

(config) # show egress-vlantag

Shows the configuration of outer VLAN stripping on egress ports.

Note:  Port level egress VLAN stripping is only supported if from/source ports are not on the same node as tool/hyrbid port with egress-vlan strip in double tag mode on GigaVUE‑HC1-Plus, GigaVUE‑TA25, and GigaVUE‑TA25E.