Replacing Control Card

This appendix describes how to replace an existing GigaVUE‑HC3 control card. There are separate procedures for the following:

■   Standalone Node
■   Node in Out-of-Band Cluster
■   Node in Inband Cluster

PREREQUISITE: Software version 5.0 or higher must be running on the GigaVUE‑HC3 node.

Before starting the procedures in this appendix, backup the entire configuration on the node to a text file. This will later be used to reconfigure the GigaVUE‑HC3 node.

(config) # configuration text generate active running upload <ftp | tftp | scp | sftp>://<upload URL>/<profilename.txt>

Note:  Be sure to use an ESD grouping strap on your wrist or ankle before touching any cards.