System LED

The system LED on the front of the chassis is as follows:

■

Slow blink RED indicates that HRoT MCU is in pre-boot phase.

■

Fast blink RED indicates that the HRoT MCU has loaded and started to execute primary/golden firmware image.

■

Slow blink GREEN indicates that the HRoT MCU has authenticated BIOS image and allowed the CPU to start booting up.

■

Fast blink GREEN indicates that the BIOS boot-up is complete. If the system has booted BIOS from the golden path, the SYS LED will continue to show “Fast blink GREEN” state even after the GigaVUE-OS is up.

■

Solid GREEN indicates that the system has booted completely via the primary path, the GigaVUE_OS is UP and the system is operating normally without alarms.

■

Solid RED indicates Boot-up failure after system is online and operational. It also indicates a critical alarm (such as over-temperature).

 

PSU Led

The individual power LED status on the chassis are as follows:

■

OFF indicates that no power is being received by the PSU.

■

Blinking GREEN indicates that the system has two PSUs of which one is operating normally without any warning/alarm and the other has no input voltage.

■

Solid GREEN indicates normal operation.

Management Port LED

The Management Port LED on the front of the chassis is as follows:

■

The LINK LED ( Left side) status are as below:

o

Off indicates that there is no link established on the port.

o

Solid GREEN indicates that a valid link at 1000Mbps is established on the port.

■

The ACT LED ( right side) status are as below:

o

Off indicates that there is no link is established on the port.

o

Blinking GREEN indicates that the port is active and is transmitting or receiving packet.

Fan Status LED

The Fan status LEDs on the front of the chassis are as follows:

■

OFF indicates that there is no power.

■

Blinking RED indicates that one fan tray is missing or failed (system can operate with one failed or missing fan tray but needs servicing).

■

Solid RED indicates that more than one fan tray is missing or has failed

■

Solid GREEN indicates normal operation is happening with all fans in healthy state.

The Fan status LEDs on the front and the rear of the chassis are as follows:

■

Solid GREEN indicates that the fan is operating normally.

■

Solid AMBER indicates that the fan has failed.