Module Removal and Replacement Procedure (Hot Removal)

The section provides instructions to remove a module from theu GigaVUE-HCT node with the power on.

Important: Hot removal of modules without following the listed steps can cause system instability and require a reboot.

Before starting, make sure you are wearing an ESD-preventive wrist or ankle strap.

Replacing a Module with the Same Type of Module

1.

Shut down the module to prepare for removal with the following CLI command:

(config) # card slot <slot id> down

2.

Slide the module out of the chassis and store it in a static-safe location.

3.

Insert the new module of the same type.

Replacing a Module with a Different Type of Module

1.

Remove all packet distribution configuration related to the module using the following CLI command:

(config) # no card slot <slot ID>

2.

Slide the module out of chassis and store it in a static-safe location.

3.

Insert the new module of the different type.

4.

Issue the following CLI command to make the card available for configuration:

(config) # card slot <slot ID>