SMT-HC1-S (Gen 3 GigaSMART Card)
GigaVUE-HC1 now supports an additional module called the Generation 3 GigaSMART card (SMT-HC1-S) delivers up to 80Gb of performance throughput. There are no front end ports on this module.
Ports & LEDs
|
Generation 3 GigaSMART Card (SMT-HC1-S) |
||||||||||
|---|---|---|---|---|---|---|---|---|---|---|
|
Maximum Modules Per Chassis |
The maximum SMT-HC1-S number of modules per chassis is two. |
|||||||||
|
Power LED (PWR) |
The LED indicates the operational status of the module as follows :
|
|||||||||
|
Ready LED (RDY) |
The LED indicates the operational status of the module as follows :
|
|||||||||
|
H/S LED |
The LED indicates the operational status of the module as follows :
|
|||||||||
|
Hot Swap Button |
Not supported in this module at this time. |
|||||||||
Upgrade Instructions
The SMT-HC1-S card was introduced with GigaVUE-OS 5.10.00 to be inserted on the GigaVUE-HC1 Chassis. The OS software is embedded on the GigaVUE-HC1 Chassis.
The addition of Threat Detection and Sensor image to GigaVUE HC1 in GigaVUE-OS 5.10.01 increased the size of the downloaded file, which can cause failures when extracting the expanded image on the target.
To install the new image follow the guidelines in this topic.
Recommended Version
The recommended version will depend upon your usage of the SMT-HC1-S module:
|
Apps on the SMT-HC1-S card |
Recommended version |
|---|---|
|
Basic GigaSMART Apps |
GigaVUE-OS 5.13.00 |
|
Gen 3 ThreatINSIGHT Sensor |
GigaVUE-FM and GigaVUE-OS v5.13.01 or the latest LTS version |
Upgrade Requirements
Upgrading from an older software version to GigaVUE-OS v5.10.01 or above is not supported. To upgrade to the latest software version, you must upgrade to GigaVUE-OS v5.10.00, first, before you upgrade to v5.10.01 or above.
To avoid failures, use the supported upgrade paths:
|
Apps on the SMT-HC1-S card |
Supported GigaVUE-OS upgrade paths |
|---|---|
|
Basic GigaSMART Apps |
older version > v5.10.00 > v5.12.xx > v5.13.00 |
