Configure Egress Port VLAN Stripping
You can enable or disable outer VLAN stripping on specified egress ports. Use egress port VLAN stripping to strip an outer VLAN tag without using a GigaSMART stripping operation.
Use the egress-vlan strip command to enable egress port VLAN stripping. The port type must be tool or hybrid.
The following examples enable egress port VLAN stripping:
Command |
Description |
(config) # port 1/1/c2 egress-vlan strip |
Enables outer VLAN stripping on a specified egress port. |
(config) # port 1/1/c3..c4 egress-vlan strip |
Enables outer VLAN stripping on a range egress ports. |
Once egress port VLAN stripping is enabled, it can be disabled with the no port <port ID> egress-vlan command.
If a port is configured for egress port VLAN stripping, the port type cannot be changed until it is disabled. To disable outer VLAN stripping on specified egress ports:
Command |
Description |
(config) # no port 1/1/c2 egress-vlan strip |
Disables outer VLAN stripping on a specified egress port. |
You can view egress port VLAN stripping using the show port params port-list bid/sid/pid command or the show egress-vlantag command.
The following examples display egress port VLAN stripping configuration:
Command |
Description |
(config) # show port params port-list 1/1/c2 |
Shows outer VLAN stripping on a specified egress port. |
(config) # show egress-vlantag |
Shows the configuration of outer VLAN stripping on egress ports. |
Note: Port level egress VLAN stripping is only supported if from/source ports are not on the same node as tool/hyrbid port with egress-vlan strip in double tag mode on GigaVUE‑TA25.