Ensure that you complete the following prerequisites before you start with Gigamon ThreatINSIGHT Sensor deployment:
Note: The latest Long Term Support (LTS) version is usually recommended. For the latest LTS release information, refer to the Gigamon Software Release Status article on the Community.
|
■
|
Generate a provision code from the Gigamon ThreatINSIGHT Portal to validate your Gigamon ThreatINSIGHT integration. The provision code that you generate is valid for 24 hours. For instructions, refer to the "Generate a Registration Code" section in the ThreatINSIGHT Portal Guides. |
Note: To access the Portal Guides, log in to the ThreatINSIGHT Portal and go to Help > Portal Guides.
|
■
|
Ensure that the GigaSMART engine port on which you want to deploy the ThreatINSIGHT Sensor has internet connectivity so that the ThreatINSIGHT Sensor can connect to AWS. |
Note: If you are installing the SMT-HC1-S (Gen 3 GigaSMART Card), use the recommended upgrade path specific to this module. Refer to SMT-HC1-S (Gen 3 GigaSMART Card), for details.
To configure the network access:
|
a.
|
From the device view, go to Ports > Ports > All Ports.
|
|
b.
|
Select the engine port and then click Edit.
|
|
c.
|
You can either manually assign the IP address or select the Enable DHCP check box to dynamically assign the IP address and other network configuration parameters.
|
|
d.
|
Select eth2 as the interface, and then click OK. |