Transceiver Installation Instructions

Gigamon transceivers are keyed and can only be installed in one direction. Transceivers are hot-swappable – they can be installed or removed with the power on or off. Use the following procedures to install and remove SFPs from GigaVUE modules.

Important: Always use an ESD-preventive wrist or ankle strap and ensure that it makes good skin contact when installing or removing SFP/SFP+ transceivers. The strap can be connected to one of the following:

•

ESD wrist strap connector.

•

Captive installation screws on an installed module or power supply module.

•

Any unpainted surface on the chassis.

Document INFORMATION

ONLINE DOCUMENTATION LIBRARY

Visit the Online Product Documentation page on the Gigamon Community to find the latest documentation offerings available online. Each online documentation portal also provides PDFs associated with that release.

Send feedback to: documentationfeedback@gigamon.com

PRODUCT INFORMATION

GigaVUE-FM 5.9

This online documentation was last updated: 12/22/2022

LEGAL INFORMATION

Copyright: Copyright © 2020-2022 Gigamon Inc. All Rights Reserved. No part of this publication may be reproduced, transmitted, transcribed, stored in a retrieval system, or translated into any language in any form or by any means without Gigamon’s written permission.

Trademark Attributions: Gigamon and the Gigamon logo are trademarks of Gigamon in the United States and/or other countries. Gigamon trademarks can be found at http://www.gigamon.com/legal-trademarks. All other trademarks are the trademarks of their respective owners