Command-Line Modes

The GigaVUE-OS CLI can operate in one of three modes, each with its own set of available commands – Standard, Enable, and Configure. When you first launch the CLI, you start in Standard mode with access to a limited amount of commands used to review system status. As you move from Standard mode to Enable mode to Configure mode, both the power and the number of commands available increase, as summarized in Figure 1408: GigaVUE-OS Command-Line Modes.

Changing to Configure Mode

Change to Configure mode as follows:

Log in to the GigaVUE-OS. When you first log in, the CLI is in Standard mode, indicated by the > prompt (for example, [hostname] >)

Type en <Enter> to switch to Enable mode.

The system prompt changes from [hostname] > to [hostname] #.

Type config t <Enter> to switch to Configure mode.

The system prompt changes from [hostname] # to
[hostname] (config) #.

If you are working over the serial console port, reset the terminal settings to match the current window with the terminal resize command.

Differences in Commands for admin and default Level Users

The commands available in the CLI are also different depending on whether you are logged in as an admin or default level user. Commands listed in bold in Figure 1408: GigaVUE-OS Command-Line Modes are only available to admin level users.

Figure 1408: GigaVUE-OS Command-Line Modes

Changing Command-Line Modes

The following table summarizes the commands used to change command-line modes:

Task	Command
Changing to Enable Mode You only need to supply enough of each command to positively identify it among the other available commands. So, in this example, you could just type en and press Enter.	> enable
Changing to Configure Mode Similarly, this command can be entered as co t.	# configure terminal
Notice how the system prompt changes with each command mode. Command modes offer greater control over the node as you ascend from Standard to Enable to Configure.	(config) #