Install U-Boot Version on GigaVUE-HC2

The U-Boot version on GigaVUE-HC2 nodes must be upgraded to version 2011.06.9 or higher. The upgrade can only be done from the CLI.

To check the U-Boot version, use the following command:

(config) # show version

For example on a GigaVUE-HC2 node, the following output is displayed:

U-Boot version: 2011.06.8

If you do not have version 2011.06.9 or higher, you will have to do a U-Boot upgrade, after the image installation. Refer to the GigaVUE H Series Upgrade Guide for details on installing an image.

After the image installation of the software, use the following command to upgrade the U-Boot version:

(config) # uboot install

The binary bootloader code included with the installed image is installed.

Note:  The newer U-Boot version only goes into effect after a reload.