coreboot
Required Command-Line Mode = Configure
Use the coreboot command to install the core boot binary on a GigaVUE-TA100, GigaVUE-TA100-CXP, GigaVUE‑HC1, or GigaVUE‑HC3 node. The Basic Input/Output System (BIOS) image can be manually upgraded from the CLI using this command.
Note: This command only applies to GigaVUE-TA100, GigaVUE-TA100-CXP, GigaVUE‑HC1, and GigaVUE‑HC3 nodes.
The GigaVUE-TA100 is introduced in software version 4.6.01. The GigaVUE‑HC1 is introduced in software version 4.8.00. The GigaVUE-TA100-CXP is introduced in software version 4.8.01. The GigaVUE‑HC3 is introduced in software version 5.0.00.
The BIOS image is packaged with the software image. Use the coreboot command to upgrade the BIOS, when required for enhancements.
The coreboot command has the following syntax:
coreboot install
The following table describes the arguments for the coreboot command:
|
Argument |
Description |
|
install |
Installs core boot binary from the active/booted image. For example: (config) # coreboot install |
Related Commands
The following table summarizes other commands related to the coreboot command:
|
Task |
Command |
|
Displays the BIOS image from which the system booted. |
(config) # show version |
