card (GigaVUE TA Series)
Required Command-Line Mode = Configure
Required User Level = Admin
Use the card command to specify how the GigaVUE TA Series node uses its physical 40Gb ports. This command also applies to white box nodes with GigaVUE‑OS.
The card command has the following syntax for GigaVUE-TA1, GigaVUE-TA10, and white box:
card slot <slot ID> mode <48x | 56x | 64x>
GigaVUE TA Series nodes only have a single card, so the slot value is always set to 1.
The following table summarizes the available options:
|
Card Mode |
GigaVUE‑OS on a white box |
|||
|---|---|---|---|---|
|
q1 |
q2 |
q3 |
q4 |
|
|
48x (default) |
40Gb (q1) |
40Gb (q2) |
40Gb (q3) |
40Gb (q4) |
|
56x |
10Gb (x49..x52 on breakout panel) |
10Gb (x53..x56 on breakout panel) |
40Gb (q3) |
40Gb (q4) |
|
64x |
10Gb (x49..x52)(x49..x52 on breakout panel) |
10Gb (x53..x56)(x53..x56 on breakout panel) |
10Gb (x57..x60 on breakout panel) |
10Gb (x61..x64 on breakout panel) |
Use break-out cables or breakout panels (PNL-M341 or PNL-M343). For breakout panel information, refer to the GigaVUE TA Series Hardware Installation Guide.
