SMT-HC1-S (Gen 3 GigaSMART Card)

GigaVUE-HC1 now supports an additional module called the Generation 3 GigaSMART card (SMT-HC1-S), which gives 80Gb throughput and can be used to provide the ThreatINSIGHT solution for security detection. Integrate this module with Threat Detection and Response functionality on GigaVUE-HC1 using GigaVUE-FM to enable faster provisioning and easier maintenance. For more information, refer to Gigamon ThreatINSIGHT Sensor, online or 'Threat Detection and Response' from GigaVUE Fabric Management Guide. There are no front end ports on this module. 

      

Generation 3 GigaSMART Card (SMT-HC1-S)

Maximum Modules Per Chassis

The maximum SMT-HC1-S number of modules per chassis is two. 

Power LED (PWR)

The LED indicates the operational status of the module as follows :

● OFF means the module is not powered up.
● GREEN means the module is powered on.

Ready LED (RDY)

The LED indicates the operational status of the module as follows :

● OFF means the module is inserted but not yet configured.
● RED means the module is failed.
● GREEN means the module is ready.

H/S LED

The LED indicates the operational status of the module as follows :

● OFF means the module is in normal operation.
● BLUE means the module is ready to be removed when, the card is shut-down or not configured. LED turns on at insertion of module.

Hot Swap Button

Not supported in this module at this time.

The SMT-HC1-S card was introduced with GigaVUE-OS 5.10.00 to be inserted on the GigaVUE-HC1 Chassis. The OS software is embedded on the GigaVUE-HC1 Chassis.

The addition of Threat Detection and Sensor image to GigaVUE HC1 in GigaVUE-OS 5.10.01 increased the size of the downloaded file, which can cause failures when extracting the expanded image on the target.

To install the new image follow the guidelines in this topic.

Recommended Version

The recommended version will depend upon your usage of the SMT-HC1-S module:

Apps on the SMT-HC1-S card

Recommended version

Basic GigaSMART Apps

GigaVUE-OS 5.13.00

Gen 3 ThreatINSIGHT Sensor

GigaVUE-FM and GigaVUE-OS v5.13.01 or the latest LTS version

Upgrade Requirements

Upgrading from an older software version to GigaVUE-OS v5.10.01 or above is not supported. To upgrade to the latest software version, you must upgrade to GigaVUE-OS v5.10.00, first, before you upgrade to v5.10.01 or above.

To avoid failures, use the supported upgrade paths:

Apps on the SMT-HC1-S card

Supported GigaVUE-OS  upgrade paths

Basic GigaSMART Apps

older version > v5.10.00 > v5.12.xx > v5.13.00

Gen 3 ThreatINSIGHT Sensor

older version >  v5.10.00 > v5.10.01 > v5.13.01  or the latest LTS version