tool-mirror
Required Command-Line Mode = Configure
Use the tool-mirror command to configure a pass-all between two tool ports or a tool port and a tool GigaStream on the same node irrespective of the maps already in place for the ports. Refer to the “Working with Map-Passalls and Port Mirroring” section in the GigaVUE Fabric Management Guide for a discussion of use cases for tool-mirrors.
Keep in mind the following rules and notes when you configure tool-mirrors:
- You can only use tool-mirror connections between tool ports/GigaStream on the same node. Cross-node tool-mirror connections are not supported.
- Tool-mirrors are not supported on tool ports with copper SFPs installed or on 100Gb ports with CFP2 transceivers.
- In a cluster, tool-mirror is supported only on the leader leader in clustering node relationship (formerly master).
The tool-mirror command has the following syntax:
tool-mirror <alias <alias>>
from <port-id | port-alias | port-list | inline-network-alias | inline-network-group-alias>
to <port-id | port-alias | port-list | gigastream-alias | gigastream-alias-list | inline-tool-alias |
inline-tool-group-alias | inline-serial-alias | bypass> [comment <comment>]
The following table describes the arguments for the tool-mirror command:
|
Argument |
Description |
||||||||||||||||||
|
alias <alias> |
Specifies the alias by which this tool-mirror will be known. |
||||||||||||||||||
|
from <port-id | port-alias | port-list | inline-network-alias | inline-network-group-alias> |
Specifies the source leader in a bidirectional clock relationship (formerly master) tool port(s) for the tool-mirror. Use one of the following:
|
||||||||||||||||||
|
to <port-id | port-alias | port-list | gigastream-alias | gigastream-alias-list | inline-tool-alias | inline-tool-group-alias | inline-serial-alias | bypass> |
Specifies the destination tool port(s) for the tool-mirror. Use one of the following:
|
||||||||||||||||||
|
comment <comment> |
Specifies a comment in up to 128 characters. Comments longer than one word must be enclosed in double quotation marks. |
The following table shows some examples using the tool-mirror command:
|
Command |
Comments |
|
(config) # tool-mirror alias toolpass from 1/3/x1 to 1/3/x12 |
Configures a tool-mirror between tool port 1/3/x1 and tool port 1/3/x12. The tool-mirror has an alias of toolpass. |
|
(config) # tool-mirror alias streampass from 14/2/q1 to mygigastream |
Configures a tool-mirror from 14/2/q1 to the GigaStream with the alias mygigastream. The tool-mirror has an alias of streampass. |
Related Commands
The following table summarizes other commands related to the tool-mirror command:
|
Task |
Command |
|
Displays all tool-mirror connections. |
# show tool-mirror |
|
Displays a specified tool-mirror connection. |
# show tool-mirror alias Tmirr |
|
Displays all tool-mirrors. |
# show tool-mirror all |
|
Displays all tool-mirrors in table format. |
# show tool-mirror brief |
|
Deletes a specified tool-mirror. |
(config) # no tool-mirror alias Tmirr |
|
Deletes all tool-mirrors. |
(config) # no tool-mirror all |
