Introducing the GigaVUE‑TA25 Chassis

The GigaVUE‑TA25 chassis consists of a 1RU, rack-mountable, 19" wide chassis with network, tool ports at the front and power connections, management, console ports at the rear. Refer to GigaVUE‑TA25 Ports and Description for a description of each of the ports.

GigaVUE‑TA25 Ports and Description

Port Description
Management

Use the Mgmt port for remote configuration of the GigaVUE-TA25 Traffic Aggregator over a 10/100/1000 Ethernet network.

Refer to installation guide for information on establishing an SSH configuration session with the GigaVUE‑TA25 Traffic Aggregator.

Console

Use the Console port for local configuration of the GigaVUE‑TA25 Traffic Aggregator over a serial connection. The serial settings are 8N1,115,200 bps.

Refer to installation guide for information on establishing a serial configuration session with the GigaVUE‑TA25 Traffic Aggregator in a terminal window.

Ports x1...x48

The GigaVUE‑TA25 provides 48 25Gb/10Gb/1Gb ports.

For details about the supported transceivers and cable type, refer to the “GigaVUE Interoperability Matrix”.

The 24-port GigaVUE‑TA25 is called GigaVUE‑TA25A. Refer to installation guide for license information to expand the 24-port GigaVUE‑TA25A to 48 ports, and to enable eight (8) 100 Gb Gb (lower-case b) is defined as Gigabit and is a unit of bandwidth measured. It is the capacity to transfer information./40 Gb ports.

Ports c1...c8

GigaVUE‑TA25 also includes 8 x 100Gb/40Gb ports (c1..c8).

In addition, you can also configure port modes that let either two (c1 and c5) of the 100Gb/40Gb ports operate as four logical 25Gb/10Gb ports .

Once a 100Gb/40Gb port has been configured to operate as four 25Gb/10Gb ports, cable it to an optical patch panel or breakout panel, which takes a QSFP28/QSFP+ input from the GigaVUE‑TA25 and splits it to four independent 25Gb/10Gb output ports. The c1 and c5 ports accept QSFP28/QSFP+ connections using 100G/40G SR and PLR4 transceivers.

Reset Button

This button on the front panel next to Gigamon logo allows you to reset GigaVUE‑TA25 without having to unplug both PSU’s. Push and hold the button for 5 seconds to reset.

Transceivers

For details about the supported transceivers and cable type, refer to the GigaVUE-OS Compatibility and Interoperability Matrix