Installing Power Modules in the GigaVUE‑HC2 Chassis

The GigaVUE‑HC2 chassis is shipped without either of its two separate power modules installed. Use the following procedure to install them.

Note:  If you are installing DC power modules, you will need to wire power to the screw terminals on the power modules before installing them in the chassis. There is not enough room to service the screw terminals once the modules are installed in the chassis. Refer to Connecting -48V DC Power Supplies for instructions on connecting DC power modules.

1.

Make sure you are wearing an ESD-preventive wrist or ankle strap.

Figure 4

Power Module (AC Version Shown)

2.

Locate the power modules and remove them from their packaging. Each module is shipped in its own box.

3.

Carefully slide the first power module into the matching receptacles at the rear of the node (Figure 1 Power Module (AC Version Shown)), making sure to fit the tab at the base of the module into the matching bay at the bottom of the receptacle. Push gently to seat the unit firmly in the chassis.

 

4.

Tighten the thumb screws to lock the power module into the chassis.

5.

Repeat the previous two steps for the second power module.