Command-Line Modes

The GigaVUE-OS CLI can operate in one of three modes, each with its own set of available commands – Standard, Enable, and Configure. When you first launch the CLI, you start in Standard mode with access to a limited amount of commands used to review system status. As you move from Standard mode to Enable mode to Configure mode, both the power and the number of commands available increase, as summarized in Figure 1.

Changing to Configure Mode

Change to Configure mode as follows:

1. Log in to the GigaVUE‑OS. When you first log in, the CLI is in Standard mode, indicated by the > prompt (for example, [hostname] >)
2. Type en <Enter> to switch to Enable mode.

The system prompt changes from [hostname] > to [hostname] #.

3. Type config t <Enter> to switch to Configure mode.

The system prompt changes from [hostname] # to [hostname] (config) #.

If you are working over the serial console port, reset the terminal settings to match the current window with the terminal resize command.

Command-Line Mode Cheat Sheet

The commands available in the CLI vary based on the mode (Standard, Enable, Configure) you are in and the user level (admin or default) of the logged in user. Figure 1shows the different commands available in the each mode and to different levels of users.

Figure 1 GigaVUE‑OS Command-Line Modes Cheat Sheet

Changing Command-Line Modes

The following table summarizes the commands used to change command-line modes:

Task

Command

Changing to Enable Mode

You only need to supply enough of each command to positively identify it among the other available commands. So, in this example, you could just type en and press Enter.

> enable

Changing to Configure Mode

Similarly, this command can be entered as co t.

# configure terminal

Notice how the system prompt changes with each command mode. Command modes offer greater control over the node as you ascend from Standard to Enable to Configure.

(config) #