Module Installation Procedure

Use the following procedure to install GigaVUE‑HC1 modules:

1.

Make sure you are wearing an ESD-preventive wrist or ankle strap.

2.

Locate the modules and remove them from their packaging.

3.

Remove the protective filler panels from the target bays for all modules to be installed. Keep the filler panels so they can be easily reused if the module is ever removed. You can install modules in either of the two available front bays on the GigaVUE‑HC1.

Note:  To prevent any improper air flow and overheating the node, do not leave any bays uncovered.

4.

Pull out the lever on the top of the module. Carefully slide the module into the bay. Push the lever back in and tighten using the thumb screw on the lever.

Figure 4

Installing Modules

5.

Install any additional modules by repeating the previous two steps.

Note:  The first time you install a module in the node, you need to configure the node to recognize it with the card command and save your changes with write memory. Refer to Configuring Basic GigaVUE H Series Settings for details.

This completes the installation of the modules on the GigaVUE‑HC1.