Interface

The Interface page (refer to Figure 1 Interface Page) shows status information about the various interfaces. To access the interface page, select Settings > interface > Interface. The page provides the following information:

Note:  Some settings can only be enable through the CLI, such as IPv6 addressing.

■   Ethernet status information(eth0, eth1, eth1, eth2, or eth2.11). The number of interfaces depends on the node model. The following information is provided about the interface:
o   Admin Status
o   Link Status
o   Duplex
o   MTU
o   ifsource
o   Autconf enable
o   Auoconf privacy
o   IPv6 addresses
o   Dhcp enabled
o   Speed
o   IP address
o   Netmask
o   Type
o   ifindex
o   IPv6 enabled
o   Autoconf route
o   DCHCPv6 running
o   IPv6 address
■   Interface inband status provides information when the node is configured for inband clustering: The following information is provided about the inband interface:
o   Admin Status
o   Link Status
o   Duplex
o   MTU
o   HW addr
o   ifSource
o   Autoconf enabled
o   Autoconf privacy
o   IPv6 addresses
o   Dhcp enabled
o   Speed
o   IP address
o   Netmask
o   Type
o   ifindex
o   IPv6 enabled
o   Autoconf route
o   DHCPv6 running
o   IPv6 address
■   Interface NDisc status provides status information about the internal interfaces for neighbor discovery. Depending on how the node is configured, there can be more than one NDisc (NDisc, NDisc0, NDisc1, and so on). The following information is provided about NDisc:
o   Admin Status
o   Link Status
o   Duplex
o   MTU
o   HW addr
o   ifSource
o   Autoconf enabled
o   Autoconf privacy
o   IPv6 addresses
o   Dhcp enabled
o   Speed
o   IP address
o   Netmask
o   Type
o   ifindex
o   IPv6 enabled
o   Autoconf route
o   DHCPv6 running
o   IPv6 address

Figure 6 Interface Page