Configure the Card Mode – 40Gb/10Gb Support

PDFs

Troubleshooting

Validated Designs

Configure the Card Mode – 40Gb/10Gb Support

GigaVUE-TA10 also enable the first four 40Gb ports (q1..q4). By default, these ports are available for use as single, logical 40Gb ports.

Refer to Configuring the Card Mode on GigaVUE-TA10 and Breakout Panels.

Changing the card mode resets all port and packet distribution settings, therefore, set the card mode during the initial configuration.

Note: The GigaVUE-TA100, GigaVUE-TA100-CXP, GigaVUE-TA200 do not support the card mode, but support the port mode. Refer to Configure the Port Mode. Then refer to Breakout Panels.

Document INFORMATION

ONLINE DOCUMENTATION LIBRARY

Visit the Online Product Documentation page on the Gigamon Community to find the latest documentation offerings available online. Each online documentation portal also provides PDFs associated with that release.

Send feedback to: documentationfeedback@gigamon.com

PRODUCT INFORMATION

GigaVUE-FM 5.8

This online documentation was last updated: 12/22/2022

LEGAL INFORMATION

Copyright: Copyright © 2020-2022 Gigamon Inc. All Rights Reserved. No part of this publication may be reproduced, transmitted, transcribed, stored in a retrieval system, or translated into any language in any form or by any means without Gigamon’s written permission.

Trademark Attributions: Gigamon and the Gigamon logo are trademarks of Gigamon in the United States and/or other countries. Gigamon trademarks can be found at http://www.gigamon.com/legal-trademarks. All other trademarks are the trademarks of their respective owners