Upgrading PLDs
Use the pld CLI command to perform an upgrade of programmable logic devices (PLDs) on GigaVUE-HC3 nodes. These devices include field programmable gate arrays (FPGAs). The following components have an FPGA:
|
•
|
control card (also referred to as the main board) |
FPGA images are bundled with the software image and upgraded with the software image upgrade, however, the pld command provides the ability to upgrade each FPGA individually.
After a PLD upgrade, the node requires a hard reboot.
Issue the show pld command to display the PLDs that need to be upgraded, then only upgrade those. Refer to the following example for CCv1:
(config) # show pld
Box ID: 1
Slot HW Type Cur Rev Need Upgrade
------------------------------------------------
cc1 HC3-Main-Board 2017/02/03:6 no
1 PRT-HC3-C08Q08 2017/01/23:5 no
2 BPS-HC3-C16 2017/09/25:1 no
3 SMT-HC3-C05 2017/02/03:5 no
4 PRT-HC3-X24 2017/01/23:5 no
Refer to the following example for CCv2:
(config) # show pld
Box ID: 2
Slot HW Type Cur Rev Need Upgrade
---------------------------------------------------
cc1 HC3-Main-Board-v2 2018/01/03:2 no
1 PRT-HC3-C16 2017/09/27:1 yes
2 PRT-HC3-C08Q08 2017/01/23:5 no
4 BPS-HC3-C25F2G 2017/07/17:2 no
Document INFORMATION 
